User control of dashboard layouts

Dashboard sheets were introduced with V9, primarily as a way to deliver mobile-friendly reporting with a responsive UI to auto-fit any screen size. Specific Targets which define the layout can be defined to optimise the layout for different devices and are automatically applied depending on the device type.

Another use-case which is less obvious but can also be very useful is to allow users to choose between a number of predefined layouts.

For example, on a specific report there may be just 3 or 4 slicers which are typically used, but occasionally users may need access to a much larger list of slicers to filter by. It would be a shame to clutter the report for everyone permanently with all the slicers as it makes the selection process less intuitive, and probably forces us to use only combo boxes to save space. Ideally we’d like users to be able to switch from a ‘Quick Slicer’ view to an ‘All slicer’ view.

Another example would be where users want to include additional dashboard items, or remove items to get a larger view of a data table.

These scenarios and others can be handled by giving users control over which Dashboard Target is active via a slicer.

In the example shown below the button slicer allows switching between a ‘Quick slicer’ view with the 3 primary slicers shown as list boxes, an ‘All Slicer’ view with all 9 slicers available as combo boxes, and a ‘Table View’ which maximises the space for the data table and removes the charts.


So how do I…?

Firstly, you’ll need to define the various Targets which you want the user to choose between (see here for the details).

Next you need to add a slicer allowing the user to select between Target layouts. This slicer will be based on an Excel range, and will output its selection to another cell which you specify. It’s easiest if the input range for the slicer exactly matches your Dashboard Target Names (otherwise you can use vlookups to cross-match). Of course you’ll need to enable that slicer on each of the targets to allow the users to switch views.

Finally, we can use the XL3SetProperty() formula to set the active Target for the dashboard, based on the output of the slicer we just set up. The syntax is:

XL3SetProperty(Object Type, Object Name, Property to set, value to set the property to)

The screenshot above shows the slicer and formula setup – hope it proves useful for some of you!

Leave a Reply

Your email address will not be published. Required fields are marked *